Perforated Wire Cut Brick
3 Hole Wire Cut Brick
- Size
- 229 × 110 × 70 mm
- Cores
- 3 round cores
Three round cores through the bed face. The everyday wire cut brick for exposed house fronts, boundary walls and general load-bearing masonry.
Golden Bricks Co. · 2 bricks
Extruded clay bricks with three or eight cores, 229 × 110 × 70 mm. The cores cut weight and help the mortar key in, and the faces come off the wire clean enough to leave unplastered.
3 hole & 8 hole
Every brick is fired at our kiln in Ambala. Tap a brick for its details or send it to us for the rate.
Perforated Wire Cut Brick
Three round cores through the bed face. The everyday wire cut brick for exposed house fronts, boundary walls and general load-bearing masonry.
Perforated Wire Cut Brick
Eight cores take out more clay than the 3 hole brick. Used for partitions, parapets and upper floors, where a lighter wall eases the load on the slab.
Not sure which brick? Ask for sample bricks or visit the kiln and pick from the stack.
Ask for samplesGuide
A perforated brick has round cores running through it from bed face to bed face. In a wire cut brick they are formed by pins in the extruder die, so every core is in the same place on every brick. Once the brick is laid, the cores are hidden and the wall shows only solid clay.
Taking clay out of the middle makes each brick lighter, which matters most on upper floors and on walls that sit on a slab instead of a beam. The 8 hole brick takes out more than the 3 hole brick.
As the brick is bedded, some mortar pushes into the cores and sets there. That small plug locks the course above to the course below.
Heat reaches the middle of a cored brick faster than a solid one, so the brick fires through more evenly in the kiln.
Pick the 3 hole brick for exposed walls and general masonry. Pick the 8 hole brick for partitions, parapets and frame infill where a lighter wall helps. Our 3 hole vs 8 hole guide goes into more detail.
Tool 01 Estimator
Enter the wall. The estimator takes out doors and windows, adds wastage and gives you the brick count, the weight of the wall on whatever carries it, and a quick check on whether the wall is too tall for its thickness.
Bricks to order
0
Height guide –
–
An estimate for ordering, not a structural design. Load uses wet mortar at 2,000 kg/m³ and leaves out plaster. Ask your engineer to confirm walls that carry a floor.
Get a delivered rate for this countProjects
01 · ExteriorFour-storey institutional block in exposed red brick
02 · Exterior · BengaluruExposed brick facade with angled window boxes
03 · Exterior · Himachal PradeshMulti-storey building with a brick facade
04 · Exterior · AmbalaHouse front with brick towers and a brick boundary wall
05 · Exterior · PunjabVilla elevation with red brick between cream bands
06 · Interior · DelhiDining area with a full-height exposed brick wall
The cores take clay out of the brick, so it weighs less, dries and fires more evenly, and gives the mortar a key to grip. The cores run through the bed face, so they are hidden once the brick is laid.
Choose 3 hole bricks for exposed fronts, boundary walls and general masonry. Choose 8 hole bricks for partition walls, parapets and upper floors where you want to cut the load on the slab.
The count per square metre depends on the brick face and the joint, not on the cores. Perforated bricks do take a little more mortar, because some of it presses into the holes.
Visit the kiln
Come to Kakkar Majra and pick bricks from the stack, or ask us to send sample bricks of perforated wire cut bricks to your site.
+91-90411-00702Book a visit or ask for samples
Send the wall size.
Get a delivered rate.